|
| |
ST-274A (94204-74 or 94204-65) Wren 2 HH AT (IDE)
+--Master on /Slave off
| +---------+
|+ Leave as is| O O O O | Power
1 J3 || 1 J2 \---------/
:::AT:(IDE):Cable::::::::::::::: :: ::::::::: 12 G G 5
-----------------------------------------------------------
ST-274A
94204-74 WREN 2 HH
UNFORMATTED CAPACITY (MB) ________________74
FORMATTED CAPACITY (26 SECTORS) (MB) _____65.5
ACTUATOR TYPE ____________________________VOICE COIL
TRACKS ___________________________________4740
CYLINDERS ________________________________948
HEADS ____________________________________5
DISCS ____________________________________3
MEDIA TYPE _______________________________THIN FILM
RECORDING METHOD _________________________RLL
TRANSFER RATE (mbytes/sec) _______________0.937
SPINDLE SPEED (RPM) ______________________3,600
BUFFER ___________________________________32 Kbyte
Read Look-Ahead, Non-Adaptive,
Single-Segmented Buffer
INTERFACE ________________________________AT
TPI (TRACKS PER INCH) ____________________960
BPI (BITS PER INCH) ______________________13489
AVERAGE ACCESS (ms) ______________________29
SINGLE TRACK SEEK (ms) ___________________5
MTBF (power-on hours) ____________________40,000
POWER REQUIREMENTS: +12V START-UP (amps) _4.5
+12V TYPICAL (amps) __1.5
+5V START-UP (amps) __0.6
+5V TYPICAL (amps) ___0.4
TYPICAL (watts) ______20
MAXIMUM (watts) ______58
BUFFERED STEP PULSE RATE (micro sec) _____
WRITE PRECOMP (cyl) ______________________N/A
REDUCED WRITE CURRENT (cyl) ______________N/A
LANDING ZONE (cyl) _______________________AUTO PARK
IBM AT DRIVE TYPE ________________________4, *
Possible translation: 940 cyl, 8 heads, 17 sectors = 65,454,080
Note: A "custom" or "user-definded" CMOS drivetype may ask for a
numerical value for the Write Precompensation cylinder and for the
Landing Zone cylinder. A basic rule-of-thumb for drive models that do
not require the old Write Precomp technique or a Landing Zone because
they are Auto-Parking is to add 1 to the cylinder value being used. As
an example: If cylinders equaled 820, then both Write Precomp and
Landing Zone would be entered as 821. Some BIOS will convert this to
65535 or -1, which are functionally equivalent to "none (not used)".
* MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO
SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE
AVAILABLE.
PHYSICAL/LOGICAL equivalent to NATIVE/TRANSLATION
WARNING - Already low-level formatted at the factory.
Since a User-definable or Custom translation geometry may be used, it
is imperative that the values be written down and kept with your
permanent records for retrieval in the event of CMOS battery failure.
Seagate reserves the right to change, without notice, product
offerings or specifications. (6/26/90) |