ST-278R ST412 RLL

(same as ST-277R with Terminator that cannot be removed, therefore
drive must be installed at the end of the daisy chain cable.)

                                                          /-4-3-2-1-\
                                                          | O O O O | Power
              o o o o o o o o                             +---------+
  +Data Cable o o o o o o o o  +Controller Cable    1       5 G G 12
 --------- -- | | | | | | | | -------------------- ---   ------------
              | | | | | | | | +------------1
              | | | | | | | | +-Terminator-+- cannot be removed
              | | | | | | | |
Drive Select->1 2 3 4 | | | + Radial
                | | | | | +-- Reserved
                | +++ | +---- Write Fault
                |  |  +------ Factory Test
                |  +--------- Never Used (Drive Select 3 and 4)
                + If twisted cable, use Drive Select 2

                          ST - 278R

       UNFORMATTED CAPACITY (MB) ________________76.9
       FORMATTED CAPACITY (26 SECTORS) (MB) _____65.5
       ACTUATOR TYPE ____________________________STEPPER
       TRACKS ___________________________________4,920
       CYLINDERS ________________________________820
       HEADS ____________________________________6
       DISCS ____________________________________3
       MEDIA TYPE _______________________________THIN FILM
       RECORDING METHOD _________________________RLL
       TRANSFER RATE (mbits/sec) ________________7.5
       SPINDLE SPEED (RPM) ______________________3,600
       INTERFACE ________________________________ST412
       TPI (TRACKS PER INCH) ____________________777
       BPI (BITS PER INCH) ______________________14,902
       AVERAGE ACCESS (ms)*______________________40/28
       SINGLE TRACK SEEK (ms) ___________________8
       MTBF (power-on hours) ____________________70,000

       POWER REQUIREMENTS: +12V START-UP (amps) _2.0/2.5*
                           +12V TYPICAL (amps) __0.5
                           +5V TYPICAL (amps) ___1.0/1.2*
                           TYPICAL (watts) ______11/12*
                           MAXIMUM (watts) ______29/36*
       BUFFERED STEP PULSE RATE (micro sec) _____3-200
       WRITE PRECOMP (cyl) ______________________N/A (821)
       REDUCED WRITE CURRENT (cyl) ______________N/A (821)
       LANDING ZONE (cyl)________________________AUTO PARK
       IBM AT DRIVE TYPE  _______________________**

       *ST277R-0/ST277R-1

 * MAY REQUIRE A CONTROLLER WITH BIOS SUPPORT, OR FORMATTING
   AND PARTITIONING SOFTWARE.  ALSO, CHECK TO SEE IF YOUR CMOS SETUP
   HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE.

Seagate reserves the right to change, without notice, product
offerings or specifications. (6/26/90)


Copyright © 1985 to 2022 Beta Systems                            Last modified: Wednesday, January 05, 2022 .