ST-4096 ST412 MFM

                                                          +12-G-G-5-+
                                                          | 0 0 0 0 |
 +Data Cable                    +Controller Cable   1     \-1-2-3-4-/
 --------- --                 -------------------- ---   ------------
              o o o o o o o o       1------------+
              o o o o o o o o       +------------+
Drive Select->1 2 3 4 | | | |          +Resistor Termination Pack
                | | | | | | |
                | +++ | | | |
                |  |  | | | + Radial
                |  |  | | +-- Recovery Mode
                |  |  | +---- Write Fault
                |  |  +------ Not Connected
                |  +--------- Never Used (Drive Select 3 and 4)
                + If twisted cable, use Drive Select 2

                              ST - 4096

       UNFORMATTED CAPACITY (MB) ________________96.0
       FORMATTED CAPACITY (17 SECTORS) (MB) _____80.2
       ACTUATOR TYPE ____________________________VOICE COIL
       TRACKS ___________________________________9,216
       CYLINDERS ________________________________1,024
       HEADS ____________________________________9
       DISCS ____________________________________5
       MEDIA TYPE _______________________________THIN FILM
       RECORDING METHOD _________________________MFM
       TRANSFER RATE (mbits/sec) ________________5.0
       SPINDLE SPEED (RPM) ______________________3,600
       AVERAGE LATENCY (mSEC) ___________________8.3
       INTERFACE ________________________________ST412
       SECTORS PER DRIVE ________________________156,672
       TPI (TRACKS PER INCH) ____________________1,031
       BPI (BITS PER INCH) ______________________9,792
       AVERAGE ACCESS (ms) ______________________28

       SINGLE TRACK SEEK (ms) ___________________6
       MAX FULL SEEK (ms) _______________________55
       MTBF (power-on hours) ____________________40,000
       POWER REQUIREMENTS: +12V START-UP (amps) _4.0
                           +12V TYPICAL (amps) __1.3**
                           +5V TYPICAL (amps) ___1.3
                           TYPICAL (watts) ______23**
                           MAXIMUM (watts) ______55
       BUFFERED STEP PULSE RATE (micro sec) _____3-70
       WRITE PRECOMP (cyl) ______________________N/A (1025)
       REDUCED WRITE CURRENT (cyl) ______________N/A (1025)
       LANDING ZONE (cyl)________________________AUTO PARK
       IBM AT DRIVE TYPE ________________________35 or 12*

 * MAY REQUIRE A CONTROLLER WITH BIOS SUPPORT, OR FORMATTING
   AND PARTITIONING SOFTWARE.  ALSO, CHECK TO SEE IF YOUR CMOS SETUP
   HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE.

       **1.5 amps/25 watts FOR 2-BOARD ST-4096 ONLY

Seagate reserves the right to change, without notice, product
offerings or specifications. (6/26/90)


Copyright © 1985 to 2022 Beta Systems                            Last modified: Wednesday, January 05, 2022 .