|
| |
ST-4182E (94166-182) Wren 3 ESDI
+Drive Selects +-------------+ 12 G G 5
1 2 3 4 5 6 7 | Term 1| +---------+
o o o o o o o | 14 pin dip | +Command Cable | 0 0 0 0 | Power
o o o o o o o +-------------++---------------+1 \---------/
---------------------------------+------------- -+--------------
+----------+1 +---------------+
-------------------+-------- -+---------------------------------
+----------+
+Data Cable
+- Motor Start option enable
|
| SW1 (located at front of drive behind the
B/Sec | Sectors | 1 2 3 4 front plate)
------+----------+-M------
512 | 34 | 1 1 0 = 151,815,168 1=on; 0=off
512 | 35 | 1 0 0 = 156,280,320
512 | 36 | 0 1 0 = 160,745,472
256 | 64 | 0 0 0
| Add Mark | 1 1 1
ST-4182E
94166-182 WREN 3 FH
UNFORMATTED CAPACITY (MB) ________________182
FORMATTED CAPACITY (34 SECTORS) (MB) _____151.8 **
ACTUATOR TYPE ____________________________VOICE COIL
TRACKS ___________________________________8,721
CYLINDERS ________________________________969
HEADS ____________________________________9
DISCS ____________________________________5
MEDIA TYPE _______________________________THIN FILM
RECORDING METHOD _________________________RLL (2,7)
TRANSFER RATE (mbytes/sec) _______________1.25
SPINDLE SPEED (RPM) ______________________3,600
AVERAGE LATENCY (mSEC) ___________________8.33
INTERFACE ________________________________ESDI
TPI (TRACKS PER INCH) ____________________960
BPI (BITS PER INCH) ______________________19,058
AVERAGE ACCESS (ms) ______________________16.5
SINGLE TRACK SEEK (ms) ___________________4
MAX FULL SEEK (ms) _______________________40
MTBF (power-on hours) ____________________100,000
POWER REQUIREMENTS: +12V START-UP (amps) _4.5
+12V TYPICAL (amps) __1.4
+5V START-UP (amps) __1.4
+5V TYPICAL (amps) ___0.8
TYPICAL (watts) ______21
MAXIMUM (watts) ______61
BUFFERED STEP PULSE RATE (micro sec) _____N/A
WRITE PRECOMP (cyl) ______________________N/A
REDUCED WRITE CURRENT (cyl) ______________N/A
LANDING ZONE (cyl) _______________________AUTO PARK
IBM AT DRIVE TYPE ________________________*
* MAY REQUIRE A CONTROLLER WITH BIOS SUPPORT, OR FORMATTING
AND PARTITIONING SOFTWARE. ALSO, CHECK TO SEE IF YOUR CMOS SETUP
HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE.
** ESDI controllers which offer an Alternate/Spare sector per track
option will format to a capacity = Cyl*Hd*(SPT-1)*512 bytes
Seagate reserves the right to change, without notice, product
offerings or specifications. (6/26/90) |