|
ST-42101N Wren 9 FH SCSI-2 Fast Wide + Synchronous Spindles option DC | Power | +-----------------------------+ /---------\ --------P-W-A---------+:SCSI:Cable:::::::::::::::::1+-+ 0 0 0 0 +-- +-+ +-+-+ +-----------------------------+ +-5-G-G-12+ |o|o o o o o o o|o+o| +------1 +------1 +------1 +o+o o o o o o o|o-o| +------+ +------+ +------+ +1+ 4 2 1 +---+ Terminator SIPS | | --+-- | | | | | | | | +- Motor Start Delay (16 secs * ID) | | | | +--- Parity check enable | | | +----- Motor Start option enable | | +--------- Drive ID's, ID 0 (none) if only SCSI device | +------------- Terminator power to the Bus (vertical) +--------------+ Terminator power from Drive, default (vertical) | Terminator power from Bus (lower horizontal) LED +---+ (Viewed from front of drive) + GND | 0 | | ----+---+-------------P-W-A--------------------------+------------ o o o J6 pin-1 (+5v) ----o o o | | | Remote LED connection --+ | | Write Protect Remote +---+ | Switch cable connection | | Factory Use Only ------+ ST-42100N WREN 9 FH UNFORMATTED CAPACITY (MB) ________________2,200 FORMATTED CAPACITY (xx SECTORS) (MB) _____1,900 AVERAGE SECTORS PER TRACK (with spares)___96 ACTUATOR TYPE ____________________________STRAIGHT ARM TRACKS ___________________________________38,595 CYLINDERS ________________________________2,573 HEADS ____________________________________15 DISCS (5.25 in) __________________________8 MEDIA TYPE _______________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (1,7) INTERNAL TRANSFER RATE (mbits/sec) _______20 to 31 EXTERNAL TRANSFER RATE (Mbytes/sec) ______20.0 Sync. (16 bit) SPINDLE SPEED (RPM) ______________________3,600 AVERAGE LATENCY (mSEC) ___________________8.33 BUFFER ___________________________________256 Kbyte Read Look-Ahead, Adaptive, Multi-Segmented Cache INTERFACE ________________________________SCSI-2 Fast Wide SECTORS PER DRIVE ________________________3,705,120 TPI (TRACKS PER INCH) ____________________2,150 BPI (BITS PER INCH) ______________________ AVERAGE ACCESS (ms) ______________________12.95 SINGLE TRACK SEEK (ms) ___________________2 MAX FULL SEEK (ms) _______________________29 MTBF (power-on hours) ____________________150,000 POWER REQUIREMENTS: +12V START-UP (amps) _4.5 +12V TYPICAL (amps) __1.5 +5V START-UP (amps) __0.8 +5V TYPICAL (amps) ___0.6 TYPICAL (watts) ______23 MAXIMUM (watts) ______ LANDING ZONE (cyl) _______________________AUTO PARK IBM AT DRIVE TYPE ________________________0 or NONE Already low-level formatted at the factory with one spare sector per track and two spare cylinders/unit. Seagate reserves the right to change, without notice, product offerings or specifications. (10/31/91) |
|